Renice 1.8" USB3.0 SSD industrial grade

U3 1.8 Native USB3.0 SSD

Renice U3 1.8" Native USB3.0 SSD is a high-capacity flash memory Solid State Drive (SSD) based on Renice U3137 USB3.0 controller. Renice Native USB 3.0 SSD is designed on MicroB connect with USB3.0 interface, electrically with USB3.0 standard, downward compatibility with 480Mbps USB2.0 High Speed and 12Mbps USB2.0 Full Speed Transfer. With Window To Go technology, industrial USB 3.0 SSD could be used for System Disk, reduces the boot time and consuming far less power than a hard disk drive (HDD). Renice USB 3.0 SSD is designed to withstand harsh environments, it is vibration resistant and can work in lower and higher temperatures. No additional drivers are required, and can be configured as a boot device or data storage device.
Basic Information
Standard USB3.0USB3.0, 5.0Gbps
Form Factor1.8-inch (78.52mm x 56.0mm x 6.53mm) L×W×H
ConnectorMicroB stand USB3.0 Connect
Capacities256GB~1TB (MLC SSD); 128GB~512GB (SLC SSD)
Input Voltage5V(±20%)
TypeIndustrial SSD
Performance
Max Sequential Data Read/Write250/160MB/s
Access Time0.1ms
MTBF>4,000,000 Hours @40C
Burst Rate200MB/S
4Kb Random Read/Write IOPSup to 25,000/8,000
Flash Memory Management
Flash Management AlgorithmStatic and dynamic wear-leveling, bad block management algorithm
Dynamic Power Management and SMART√
BCH ECC12/24/40/52/64/72 ECC per 1k Byte, CRC16 per meta data
Other Functions
Power Failure Protection√
Over Voltage Protection√
TRIM√
Secure EraseOptional
Environment
Temperature Ranges-40°C to +85°C
Humidity5-95%
Vibration20 G (7-2,000HZ)
Shock2,000G (@0.3ms half sine wave)